Call 800.835.2838 or 316.263.9511Email
Distributor to Industry, Inc.
All Categories > Industrial Air Valves > Aventics Industrial Air Valves > Aventics Ceram™ ISO 5599-1 Subbases and Manifolds > Rexroth Ceram™ Subbases & Manifolds, Size 2 > Rexroth Ceram™ Manifold Accessories, Size 2 and 3 > Item # 0821302050  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # 0821302050, Sandwich Pressure Regulator


Ideal for applications within a manifold where a particular pressure is required for one or more valves. Our regulator controls inlet pressure through to each cylinder port. A relieving type, the knob will also lock into a given position. Kit includes regulator (1), gasket (1), screws (4), plus gauge for the 10-120 psi model.




Specifications  · Advantages

Specifications

Old Part #
0821302050

Height
2.64 Inch
67 mm

Length
11.22 Inch
285 mm

Ports
1

Pressure Rating
10-120

Configuration
Comes with gauge, gauge port is G 1/8.


Advantages
Eliminate Downtime-They Don’t Stick
Normal air valves can stick or jam and cause start-up problems because of their inability to handle accumulations of dir, dust, oil or water in air lines. Not with the Ceram valve. There’s no gap between the plates for dirt and oil to accumulate. The plates are finished so precise that they act like sliding magnets or jo blocks. Solenoid operators of the same voltage on standard valves are interchangeable between all sizes, reducing spare parts inventory and downtime.

They Work Great in Normal Applications Too
Just because they are so popular in harsh environments, don’t think they won’t work great in a more normal application.

Ceram Valves Save Air and Money
The tight shut-off with Ceram valves eliminates costly loss of air that is common in other designs. Compressed air that you pay for.

Extended Life
Years of proven field service verifies an anticipated life of 150 million cycles even under adverse conditions.

Overcomes Design Limitations of Other Valves
Lapped spool valves normally have a small gap between spool and sleeve that is prone to oil and dirt accumulation, resulting in sticking and the waste of air. Packed spool valves using elastomer seals are subject to deterioration and excessive wear when contamination and/or incompatible lubricants are present.


 DOWNLOADS 

Internal to External Pilot Field Conversion, Sizes 3 and 4
(PDF, 110KB)

Piping Procedures
(PDF, 109KB)


Site created by ThomasNet Web Solutions and powered by Navigator Platform